Cover up your pod filter from direct engine heat without affecting
air flow! These universal heat shields help direct cold air into your
pod filter, increasing efficiency to make your car run at its best.
This cover is immaculately built, made from heat proof plastic(PE - Polyethylene) and
finished in a high gloss enamel. It looks fantastic in the engine bay
and will fit almost any pod filter on the market, even filters with a
large 4" neck. Please check the dimensions below against the your
current pod filter and the space available in your car.
DIMENSIONS:
Hole for filter neck = 10cm (more than 4")
Minimum inner diameter = 16.2cm (your filter must be smaller than this diameter for correct fitment)
Maximum length = 18.5cm (from the side with filter neck hole to the lip)
Maximum lip diameter = 19.5cm (the diameter of the opening opposite the filter neck hole)
Color available: Carbon black and carbon gold.
NOTE: The images show air ram intake kit and a pod filter with a 3" neck installed. This is for illustration purposes only and there are not included.
DIMENSIONS:
Hole for filter neck = 10cm (more than 4")
Minimum inner diameter = 16.2cm (your filter must be smaller than this diameter for correct fitment)
Maximum length = 18.5cm (from the side with filter neck hole to the lip)
Maximum lip diameter = 19.5cm (the diameter of the opening opposite the filter neck hole)
Color available: Carbon black and carbon gold.
NOTE: The images show air ram intake kit and a pod filter with a 3" neck installed. This is for illustration purposes only and there are not included.
 |
| Sample Picture for Campro Engine |
0 Comments:
Post a Comment